Brocade REST interface is only available for Fabric O8.2.1 and higher. Visit Network layer for more information.
Prepare your Switches and Directors: Brocade SAN Switch preparation
Select +Brocade and fill out the mandatory fields
Do not change the defaults unless there is an important reason to do so.
Select a Switch (or Director) in your SAN that has the highest firmware level and has the most performant hardware (Core directors preferred) and insert its address in the corresponding fields Insert the user credentials you prepared in Step 1 Click "Update switches" below "Discovered switches" → this will take a while, please be patient BVQ will discover the IP addresses of all connected Switches and will ask every discovered Switch for additional connected Switches until no more Switches are found. All discovered Switches are Part of a (virtual) Fabric and all discovered Fabrics are part of a SAN, that is scanned completely by this BVQ Scanner instance.
It is essential, that the principal switch of each fabric can be found in that discovery to identify all the Fabrics inside that SAN. Please review the list of discovered Switches for completeness It is recommended to have the same user credentials on all Switches. If that is not possible, you can change the user credentials of each Switch found in the first discovery. Please hit "Update Switches" again after that, if the list of Switches is not complete as expected.
After setting up this Scanner hit the "Save configuration" button to finish your work.
|